Nanobubble generator for DFT water basins
On this page, we will offer expert recommendations and detailed project case studies to help you effectively implement nanobubbles in your DFT water basins.
If you can’t find the information you need, please feel free to contact us.
What do you want to know about nanobubbles?
Why use nanobubbles for DFT water basin?
Our nanobubble technology provides a multitude of benefits. Here are several compelling reasons to consider integrating nanobubble technology for your DFT water basins.
- Increased nutrient uptake
- Improves root development
- Better resistance to environmental factors
- Stimulates positive bacteria and fungi
- Reduces stress in the plant
Our recommendation for DFT water basins
For dosing nanobubbles into a DFT irrigation system, we recommend using our Triton systems, the included tank mixers ensure proper distribution throughout the silo.
When using Nanobubbles on a DFT irrigation system the Triton system should be equipped with our O2Solutions maintenance free built-in dissolved oxygen regulator, which maximises the oxygen level in the silo to prevent over dosing and optimum control of the DO levels in het irrigation system.
Learn more about the TritonNanobubble generator capacity
It’s crucial that the nanobubble generator has sufficient capacity for dosing nanobubbles into your DFT water basins.
For accurately determining the appropriate capacity of the Triton system, we advise consulting our experts for calculation. Feel free to reach out to us if you require assistance with capacity calculations.
Get in touchLatest projects
We have recently provided the following companies with a nanobubble generator for their DFT water basins.
Installation nanobubble generator at a DFT water basin
The Triton system arrives fully assembled, including all necessary PVC fittings for installation on DFT water basins. The delivery includes:
- Triton nanobubble generator
- Bracket with PVC couplings for mounting the pipework on the edge of the DFT water basin
- Suction and tank mixer for optimal mixing of nanobubbles in the basin
As a customer, you only need to supply your own 50 mm PVC pipe.
The nanobubble generator comes pre-configured from the factory and is ready for quick commissioning in your DFT water basin.
Maintenance nanobubble generator
O2Solutions’ unique design guarantees maintenance-free operation of the system for DFT water basins.
Unlike other systems on the market, our nanobubble generators require no chemical cleaning during use.
The only maintenance required is an annual check-up of the oxygen concentrator, which our service departments in the Netherlands and Canada will coordinate and perform for you.
Frequently Asked Questions (FAQ)
We recommend keeping a value between 15 and 20 ppm to get the optimal result.
If fertilisers are also dosed to the DFT water basin, the DO reading on the Nanobubbles system should not be set above 17ppm to avoid reaction with iron chelate.
Technically, the Triton needs a pre-filtration of 1,000 microns to protect the device, but for the optimal performance of nanobubbles, a pre-filtration of at least 40-60 microns is advised.
Broadly speaking, yes, with the exception of crops with a high organic load in the water, in which case the dosage should be higher.
- Make sure all supply lines entering the silo are below the water level, this gives higher efficiency, falling water causes nanobubbles to explode.
- Make sure the intake line of the irrigation unit is properly sized and does not pull too much vacuum, as vacuum pulling causes the nanobubbles to explode to larger bubbles and come out of the water.