Nanobubble generator Triton
€ 7.995,00
- The best nanobubbles solution for greenhouse horticulture
- Maintenance-free
- High efficiency 24/7
- No problems with dirty membranes.
- Don't need periodic cleaning with chemicals required
- Highest efficiency with lowest oxygen consumption
- Approved according to European and North American quality marks

Applications
The Artemis is applicable for the following applications.
Productinformation
About nanobubble generator Triton
Triton is designed with the patented VPOD technology. The unit can be mounted directly to the wall of a water silo. The system circulates over the silo to increase the oxygen level. This is done by a special silo mixing technique, which ensures that the entire silo is fully treated within moments.
Vacuum Pressure Oxygen Dissolving > VPOD
How does the Triton operate?
The Triton is equipped with a stainless steel pump that draws water from the silo and forces it through the VPOD reactor under high pressure. The oxygenated water with nanobubbles is then pumped back into the silo to treat the entire silo in a short time via the special silo mixing technique.
The Triton system is assembled on a mounting panel that can be fastened to the wall of a water silo with supplied mounting brackets. The supply and drain pipes go over the edge to the bottom of the silo. The Triton is delivered plug and play including all mounting materials. The Triton’s built-in controller controls the VPOD process and can regulate the oxygen dosage in various ways:
- Based on external start/stop signal
- Based on built-in timer
- Based on optional dissolved oxygen measurement
The Triton can increase the oxygen level in the water using outside air or via pure oxygen from an oxygen concentrator. The oxygen concentrator is of industrial quality with built-in oil-free compressor and can supply oxygen up to 3 Triton systems.
Technical information
Silo capacity | < 400 m³ |
Daily renewal rate | 650 m³ per day |
Power supply | 230V |
Silo mixing flow rate | 40 m³ per hour |
Power Triton | 0,9 kWh |
Power O2 concentrator | 0,35 kWh |
Oxygen concentration | 93% |
Oxygen flow | 2 to 5 liters per minute |
Technical comparison
Criteria | O2 Solutions | Brand "M" |
---|---|---|
Oxygen flow @ >90% | 5lpm | 5lpm |
Power consumption | 1.2 kWh | 2.7 kWh |
Pump flow | 40m³/h | 34m³/h |
Recommended daily irrigation capacity | 650m³/day | 400m³/day |
Oxygen transfer efficiency day 1 | > 90% | 90% |
Oxygen transfer efficiency day 30 | > 90% | 48% |
Oxygen transfer efficiency day 60 | > 90% | 26% |
Oxygen transfer efficiency day 90 | > 90% | After chemical cleaning 86% |
Oxygen transfer efficiency day 120 | > 90% | 44% |
Oxygen transfer efficiency day 150 | > 90% | 23% |
Oxygen transfer efficiency day 180 | > 90% | After chemical cleaning 86% |
Chemical cleaning of the generator | Not necessary | Weekly to monthly |
Daily operations | Nothing at all | Weekly monitoring of fouling in the system |
* The efficiency tests were conducted in practice on drain water from a rockwool substrate. Water with higher organic contamination, such as crops on water and crops using potting soil, causes even faster contamination of the nanobubble generator (Brand ‘M’). It is 100% guaranteed at O2solutions that the dissolution rate remains the same all year round with any water type.
** Due to fouling of the system (Brand ‘M’), oxygen flow slowly decreases and the operator needs to continuously check and adjust the system to avoid failure.
Financial comparison
Criteria | O2 Solutions | Brand "M" |
---|---|---|
Investment nanobubbles system | 30% to 40% lower | |
Installation cost | 500 Euro / 550 USD | 1,500 Euro / 1,650 USD |
Energy savings | 50% lower | |
Yearly maintenance cost | Always below 1,000 Euro / 1,100 USD | Aprox. 2,000 Euro / 2,200 USD |
Chemical cleaning cost | 0 | Can go up to 1,500 Euro / 1,650 USD / year |